Digital to analog converter using R 2R ladder network and 741 op amp with simulated output waveform

By
Khaleel
3 Comments

What is DAC? Digital to analog converter (DAC) is used to get analog voltage corresponding to an input digital data. Data in binary digital form can be converted to corresponding analog form by using a R-2R ladder (binary weighted resistor) network and a summing amplifier. It is more common and practical. Below is the circuit and output simulated waveform of R-2R ladder network DAC. This circuit also uses an op amp (741) summing amplifier circuit.
You can learn how to build a Digital to Analog converter using the simple technique explained in this page. Actually different types of Digital to Analog converter ICs are available commercially based on this same principle. The R-2R ladder network is build by a set of resistors of two values. It makes the circuit more simple and economical for different applications.
Circuit Diagram

Components Required
Resistors (1KΩx4, 2KΩx5)
741 Op Amp
7493 Counter IC
Working of R-2R ladder network DAC
R-2R weighted resistor ladder network uses only 2 set of resistors- R and 2R. If you want to build a very precise DAC, be precise while choosing the values of resistors that will exactly match the R-2R ratio.
This is a 4 bit DAC. Let us consider the digital data D3D2D1D0= 0001 is applied to the DAC, then the Thevenin equivalent circuit reduction is shown below.

Vref is nothing but the input binary value reference voltage, that is for binary 1, Vref=5V and for binary 0, Vref=0V.
For 0001 only D0=Vref, all other inputs are at 0V and can be treated as ground. So finally Vref/16 volt is appearing as the input to op amp. This value gets multiplied by the gain of op amp circuit – (Rf/Ri).
If we proceed in this manner (Thevenin equivalent reduction), we will get

Note that you can build a DAC with any number of bits you want, by simply enlarging the resistor network, by adding more R-2R resistor branches.
In this circuit the 7493 IC simply provides digital inputs to DAC. It is a counter IC and not an integral part of the DAC circuit. You can apply any combinations of binary inputs to D3D2D1D0
Output waveform

Components pin out

[email protected] Lab

Related Circuits:
ADC Block DiagramWhat is analog to digital converter- ADC using LM324 IC BPSK modulation Circuit DiagramBinary Phase Shift Keying (BPSK) modulation using CD4016 with Simulated output waveform Triangular Wave Generator circuit using op ampTriangular wave generator using Op Amp 741, circuit working and simulated output waveform Analog to Digital Converter circuit diagram using PIC MicrocontrollerAnalog to Digital Converter Using PIC16f877A Microcontroller – Beginners Guide
3 thoughts on “Digital to analog converter using R 2R ladder network and 741 op amp with simulated output waveform”
[email protected]’abin pathroseMarch 28, 2015 at 1:33 am
working can be explained more….|good

Reply
[email protected]’raviJune 29, 2015 at 12:38 pm
Is it possible to change the resolution?
if answer is yes how can i make each step size equal to 1V? pls explain or mail me [email protected]

Reply
[email protected]’kaustubh kherMarch 21, 2016 at 3:48 pm
dear sir,
pls explain that whether it is possible to apply 5 v input directly to the resister network through switch
by removing ic 7493
waiting for your comments